Wrapping Gown

When this most elegant of 18th century dresses first appeared in the 1710s, it resembled a wrapping gown. It had no waist and there were no fastenings as it was pulled over the head. The front was sewn closed from the waist down, bound with ribbon all down its front, or left hanging open. They were worn as undress, i.e. informal day wear. Sometimes sleeves had relatively simple cuffs of a rectangular shape with 2-3 pleats to make them narrower at the nick of the elbow or left plain.

Until the 1740’s, it gradually developed a waist, opened in front, became more decorated and, like all dresses, wider. By the middle of the century, the gown had developed variations that could be worn for formal off-court occasions, e.g. weddings and soirees.

La Robe Francaise – Court Dress

By the 1770’s the sack-back gown was second only to court dress in its formality. In front, the gown was open, showing off a decorative stomacher and petticoat. It would have been worn with a wide square hoop or panniers under the petticoat.

Scalloped ruffles soften trimmed elbow-length sleeves, which were worn with separate frills called with double and triple flounces, not counting the lace flounces attached to the chemise sleeves.

It now had the back arranged in box pleats which fell loose from the shoulder to the floor with a slight train. The painter Watteau was so fascinated by the play of the large pleats in back that he painted them over and over again. Today these pleats are known as Watteau pleats.

Making the Robe

Silk Taffeta, Damask or printed cotton 

The Française was not exclusively upper class, but the sheer amount of fabric that goes into its construction made it unaffordable for anyone who didn’t make a comfortable living. For the middling sort, it served as Sunday best. This means that the fabric should be of the better kind – either silk damask, silk taffeta or printed cotton. – I’ve been asked about the fabric weight. Consider that heavier fabrics weigh down skirt supports, especially wide ones, so that you may need stiffer (and heavier!) steels in the panier.

As for the amount, for those who want it in a nutshell: 10-12 metres @ 90 cm width will suffice, a small safety allowance included. 1-2 metres more for patterned fabrics. You may think that this is an awful lot of fabric. Yes, it is. You may think that you won’t need as much because you’re petite. No, believe me, you will need it. It doesn’t make much difference whether you’re slim or fat. Even if you’re on a budget, an 18th century robe is nothing to be niggard about.

Linen for Dress Lining/Petticoat

For the lining, you also need roughly 150 x 75 cm of a firm linen-weave fabric. The lining will hold the whole construction up, so it mustn’t be too weak or be distorted easily.  You also need to make a toile that is a mock up in cheap non-stretchy sturdy fabric so not expensive mistakes are made with the silk. It should be the colour of unbleached cotton or linen or match the top fabric or go well with the top fabric while being inconspicuous.

Sometimes the petticoat was made of plain linen and only covered with the fashion fabric where it showed, i.e. in front and partly up the sides and back.

Washing

Most books recommend washing the fabric before cutting in case it shrinks. In case of silk, however, that is risky: Silk tends to lose some of its shine and stiffness. 

Making the Pattern

The most important part of the dress construction is lining as it determines the shape and fit of the finished garment. If the lining fits properly, so will the robe as it is simply draped onto the lining.As the Robe, a La Francaise is only fitted round the front and can easily be adjusted to two or three dress sizes.

You should also have the corset finished first: The robe can only fit properly if it is draped on the corseted figure. And the panier should also be finished since its size and shape determine the length and width of the skirt and thus, the fabric consumption. 

LINING AND LACING AND PLEATS

Cut a mock-up of the lining out of cheap fabric like calico first. This is called a toile it allows mistakes to be made without wasting expensive fabric. Lightly baste or pin the back, sides and fronts including the under stomacher (not sleeves) together and put it on over the stays, allowances to the outside. Make sure it fits properly – so it lies smooth – adjustments, if any are necessary, should be marked directly on the fabric so this can be used as a template for the lining fabric.

The proper lining fabric is then cut out and sewn together to create the body and sleeves of the dress lining.  The under-stomacher is sewn into the lining – it has eyelet holes and is designed to take the stress often placed on fancy stomachers. Also, the purpose of the front facing on the under stomacher is somewhere to pin the decorative stomacher later.

Back Lacing

Ties have been added to the back of the lining for adjustability.

Cut 10 pieces of twill tape 12” long – pin each end of tape as indicated on the pattern – tapes will lie on the outside so it is easier to adjust for the wearer. Make a casing with twill tape stitch down over the tapes then insert boning.  I have used covered 6mm sprung steel – then pull the tapes in to make a perfect fit – The boning will keep the back straight and smooth. It should be necessary to adjust the back tapes only once.

The design should enable one to let out the torso of the gown sufficiently so it can be worn through early pregnancy or taken up an entire size. 

Draping the Robe – The back is pleated into two large pleats and must be symmetrical (as my fabric isn’t wide – I had to join it off centre).  Then sew the top fabric pleats onto the back-neck piece. The Front and back pieces of the gown also have had the fabric folded back from shoulder to hem – these are called robing’s – they will be decorated later.

The front and back are then sewn together along the shoulder seams and at the sides.

A side skirt extension which is a large rectangle of fabric is sewn to the back and front of the skirt sides to increase the skirt width and then pleated to make the side pockets.

The dress is now attached to the lining – along the neckline and down the front under the under stomacher. It is also attached at the top side seams, at bottom of side seam and on top of pocket pleats.

Sleeves

Sew the seam of the sleeve and then attach the sleeve into the armhole by 4-6 small pleats.

SLEEVES ENGEANTES

The sleeve engeantes or flounces then need to be attached – there are two on each sleeve a smaller and a larger. Gather the upper edges of the flounces and sew them on with a little head.  The smallest flounce sits on top. The longest part of the flounces is at the outside of the elbow, where the sleeve is longest.

Hem

Put on the robe over stays and pannier. Be sure to wear your period shoes or heels the same height as those of your period shoes. the front edge, the skirt should 5-8 cm above ground. At the sides, it should be floor length or 2-3 cm above. In back, the train length is a matter of taste All the more reason to attach a cheap hem protection fabric to the inside of the train.

 STOMACHER PATTERN

From about 1740, most gowns and bodices were worn to reveal a stomacher, a stomacher is a decorated triangular panel that fills in the front opening of a woman’s gown or bodice. The stomacher may be boned and cover the triangular front of a corset.  This stomacher is decorative, the bodice’s lacings would then criss-cross over the stomacher or be pinned.

They could be made of the same fabric as the dress or of a contrasting fabric. Depending on the period, their bottom point was at waist level, or lower; towards the end of the 18th Century they could be as deep as 10 inches below the waistline, making it impossible for the woman wearing them to sit.

Once the under stomacher is laced centre the stomacher over the lacing and pin to the top edge of the facing of the lining. The pinning line corresponds to the stitching line.

Making the stomacher

Pin stomacher interfacing together and sew boning channels, pin stomacher lining to stomacher. Pin interfacing to wrong side of lining stitch all layers together leaving top of stomacher open. Turn stomacher right side out and insert boning into casings. Fold remining seam allowance to inside of stomacher.

Decorating the Stomacher

For a 1750-1770 robe, the most common trims were bows and gathered or pleated strips of top fabric, So I decorated the stomacher with box pleated silk sewn waving down the stomacher and trimmed it with bows and very fine antique gold and pink trimming. Trimming was usual narrow and the same colour as the garment, as here many formal gowns were trimmed with metallic trims. The narrow band of lace sewn to the top edge was called a tucker.

Fabric was very costly so only the extremely wealthy could display such extravagance in trimmings. The stomacher is a very attractive item which you can replace quite easily – a different stomacher can ring the changes with any gown!

The result is a beautiful gown that can be worn for any court event!

Bath costume exhibition

I am writing a new talk about Fashion and Queen Marie Antoinette.  I have already designed and made a number of garments for my new lecture which include period underwear, a Chemise a la Reine, a wig and I am now finishing my spectacular La Robe Francaise.  It is now fully constructed and only needs to be decorated. I thought it would be a good idea to visit the fabulous Fashion Museum at Bath to see some extant gowns before deciding on how to complete my dress.

It is a fabulous museum and there were a number of dresses similar to my gown to which I could look to for inspiration.They included a cream gown, a rust striped gown, a blue gown and a brightly coloured gown of painted silk. I have included pictures of the all the dresses however I really loved the cream silk robe.

Cream dress

It is a fabulous and very elegant silk gown with lovely embellishments so I decided to include a similar type of trimming for my dress to give it both an authentic and a very attractive look.The lightweight cream silk Robe a la Francaise (called a sacque back in England as it hangs in folds from the top of the shoulder) included a slight train.

Pale Blue Gown

Almost all the Francaise are silk and tend to come with stomacher and petticoat. As they were usually silk rather than linen (which was cheaper and re-used) they were saved through the years as an expensive artefact. They tended to have luscious trimmings, lace or furbelows and needed to use more fabric which adds to their importance. (My gown has already swallowed up 14 yards of rose pink pure silk brocade fabric).

Detail of cream dress skirt front showing furbelows

The cream gown on display is cream striped silk brocade with a matching petticoat and an open front. The bosom is covered by a decoration mounted on a stomacher piece, or by a false front (a compere). The false front was decorated by a dressmaker – it is interesting to note that if it was embellished with ribbons it then came in the remit of a milliner! The stomacher has been decorated with a strip of fabric which is hemmed and box pleated then sewn down the centre with additional narrow curving trim on each side for decoration. A flat bow finishes the bottom edge of the stomacher.

Rust coloured striped Dress

The dress is decorated with Furbelows (strips of fabric hemmed, pinked or frayed which could be edged with narrow trim) – which are either gathered or box pleated and sewn to the dress. This dress has box pleated furbelows trimmed with narrow braid sewn down around the edges of the gown down the front and around the neck.

There are more strips of fabric in varying width gathered and box pleated curving down the sides of the gown.  If you look carefully you can see that there are also circles of fabric gathered and finished off with trim that are reminiscent of flowers – these are sewn to the front of the dress.

Pale Blue Gown

Treble flounces finish the sleeve – they are finished with a narrow hem or trimming then box pleated onto the sleeve. Ruffles of white embroidered lawn or lace are worn beneath them. The ruffles would have been tacked to the end of the sleeve so they could be removed for laundering.

Detail of cream dress skirt front showing furbelows

The petticoat is designed in matching fabric and also decorated with two furbelows which have been gathered and box pleated. If you notice the wide Furbelows are sewn down the middle and the narrow ones only down the edges. I was unable to take a picture of the back of the cream silk gown so have included a photograph of the back of my pink silk dress which is similar in style. If you look closely you can see the pins attaching the neck trim – as this dress is still not finished!

My Pink Silk Marie Antoinette Gown

When I have completed the gown I will include details of the construction of my gown from start to finish on my website.

This cream 18th Century Dress is a very attractive gown of the period and I am really looking forward to decorating my rose pink gown in this style!

.